If your refrigerator is over 10 years old, you may notice that it is dripping water. This is not unheard of. What do you do if you see a puddle of water surrounding your Whirlpool fridge? What could be causing this leak, and what could be done to stop it? We’ve looked into the possible causes of this problem in Whirlpool refrigerators and have some answers for you in this post.
It’s likely that your refrigerator has a water line, drainage leak, or condensation problem if there is water at the bottom. The following are some of the most frequent causes of these problems:
- The drain pan is shaky.
- a water line has been harmed
- Leaks have been discovered in the water filter.
- A clog has formed in the defrost drain.
- There is a problem with the water inlet valve.
Even though Whirlpool refrigerators are among the most reliable on the market, they are prone to a number of problems, especially as they get older. Continue reading to find out how to fix a leaky faucet and when it’s time to replace your water heater.
Common Reasons For Whirlpool Refrigerator Leaks
It’s not always a bad idea to have a leaky refrigerator or kitchen floor. You can fix some minor leaks within minutes, while others may require more extensive troubleshooting and pricey repair.
In order to save money, it’s usually preferable to try to track down the leak’s source before calling in a professional.
The Drain Pan Is Unlevel
The drain pan itself can also be the source of problems. Water that drips down from the refrigerator’s numerous systems ends up in the drain pan, which collects it. The condenser fan usually helps to evaporate this water.
Any of these flaws can cause water to seep out of the pan. You can check to see whether this is true by removing the bottom grill drain pan. The back of the refrigerator is usually where you’ll find it.
Make sure that the pan is in good condition and that it is correctly installed. It will have to be replaced if it is damaged. You should also make sure that it is level with the bottom of the refrigerator, if it has been put incorrectly.
The Water Line Is Damaged
The most common cause of a leaky refrigerator is a water line that has been broken or loosened. This long plastic hose links your home’s water supply to the refrigerator’s water dispenser and ice-maker.
If the leak in the refrigerator begins at the end of the water line, it is likely that the fitting on the valve is damaged or too loose to function properly. If the problem is with the line itself, a small crack or puncture may be all that’s needed to start the leak.
If this is the case, the solution is simple: simply replace the hose. Tightening the valve may fix the connection problem. You’ll have to buy a new valve if the old one is damaged.
The Water Filter Is Leaking
Refrigerant leaks are sometimes caused by water filters, which is not unusual. If you’re looking for a simple repair that you can make yourself, this is it. When you go to collect ice or drinking water, you may notice a leak if the water filter isn’t properly positioned in its housing.
Incorrect installation and damaged or malfunctioning filters are other potential sources of leakage. It’s also a good idea to make sure that the new generic-brand water filters fit properly, as they can also leak.
The Defrost Drain Is Clogged
The defrost drain is likely to be the source of the leak if you see it coming from the rear of the refrigerator. Refrigerator defrost water is routed down this drain to a collection basin situated beneath the unit for disposal.
Puddles will form on your kitchen floor if the drain becomes clogged with water. Occasionally, a small amount of water that has accumulated in the drain can cause a leak.
Unclogging the drain is the quickest way to fix this problem. With hot water, you can do this on your own, or you can hire an appliance repairman to handle it.
The Water Inlet Valve Is Loose Or Broken
To keep the refrigerator stocked with ice and water, the water inflow valve is periodically closed and opened. This part is normally hidden under the lower bottom edge of the refrigerator, right next to the waterline, and is easy to miss otherwise. Refrigerators must be removed from the wall to be accessed.
You can tell whether or not you’re dealing with a leak by looking at the valve. Check to see if the leak is stopped by tightening the valve if it appears loose. Another quick and low-cost remedy, you may complete it in 15 to 20 minutes by yourself.
However, if this doesn’t solve the problem and you’ve tried everything else, you may need to contact a technician.
How Do You Stop Water From Leaking At The Bottom Of A Fridge?
Maintaining the drainage system of your refrigerator to ensure that it is free of damage and obstructions is the best approach to stop water leaks.
The drain pan, water line, water entry valve, and defrost pan are all included here. These are the regions where leaks are most likely to occur. In addition, make sure the water filter is properly installed and free of damage.
Where Is The Defrost Drain On A Whirlpool Refrigerator Bottom Freezer?
Most Whirlpool refrigerators have defrost drains located on the lower rear wall of their refrigerators. The ice and water from the waterlines normally flow to the bottom. You should begin your search for the source of a refrigerator leak in this area.
How Do You Unclog A Whirlpool Refrigerator Drain Tube?
To unclog a drain, it’s best to first consult your appliance’s owner’s manual. To get to the drain, you’ll need to remove the refrigerator from the wall. Disconnect the refrigerator’s power cord next, so that water won’t keep flowing while you inspect the appliance.
Once you’ve gained access, remove the water inlet valve and use a turkey baster to melt any ice that has built up. Afterwards, twist the tube back onto the inlet valve and re-connect the power cord, and you’re done.
How Do I Fix A Leaking Whirlpool Refrigerator With A Freezer On The Bottom?
The leak’s origin is an important consideration. Water lines on these refrigerators may be different from those on side-by-by-side models. However, the following are steps you can take to address this problem:
Empty The Drain Pan When The Humidity Is High
It may be surprising to learn that environments with high humidity can cause refrigerator leaks. The humidity in the air can mix with your fridge’s cold temperature, causing condensation to fill the drain pan faster than it normally would.
The fact that high humidity can cause refrigerator leaks may come as a surprise to many people. Refrigerator condensation can build up more quickly than usual if the chilly temperature of the unit mixes with the ambient humidity.
Check Your Door Seals
Condensation can develop up under the refrigerator and freezer if the door seals aren’t properly maintained. When the freezer and refrigerator doors are left open for an extended period of time, the motor is forced to work extra hard to keep the interiors cool.
Check For A Blocked Defrost Drain
Defrosting drains can become clogged even though your freezer is placed at the bottom of the refrigerator. After removing the drain from the refrigerator, run a hot water tap for 1 to 2 minutes to clean it. As a result, if the drain has been damaged, you’ll need to get a new one.
How Does a Refrigerator Work?
Compressor, condenser coils, evaporator coils, and an expansion device make up the refrigeration cycle. To keep your food fresh, here’s how they work together.
- Refrigerant is compressed by the compressor and sent into the coils on the outside of the refrigerator, increasing its pressure.
- Liquid is formed when the hot gas in the coils comes into contact with cooler kitchen air.
- The refrigerant cools down as it passes through the coils inside the freezer and refrigerator now that it is a liquid under high pressure.
- Because it acts as a heat sink, refrigerant helps to keep food cool.
- Finally, the refrigerant is converted to a gas and returned to the compressor, where the cycle is repeated.
How to Care for Your Refrigerator
In the bottom of bins, the solid blocks of ice that have been absorbed by freezer scents will form. Empty ice bins periodically and start fresh; store an open package of baking soda in the freezer to absorb odors.
Every Three Months Maintenance
Refrigerator door gaskets can become dirty and flimsy, preventing the doors from closing properly and increasing the strain on the motors. Use soapy water to wash and dry dirty gaskets. If the magnets contained in seals are loose, they should either be replaced or re-magnetized.
To re-magnetize, all you need to do is run a strong magnet down each side of the gasket 50 times in the same direction.
In the back of your refrigerator, you’ll find condenser coils that cool and condense refrigerant, releasing heat. The compressor is stressed and energy is wasted if the filters are blocked with dust and pet hair.
The condenser coils and fan should be vacuumed with a brush attachment every three months. Then, use a refrigerator coil brush ($7) to clean the rear and sides of the coils, which are difficult to reach. Pet shedders should have their coils cleaned at least once a month.
If your refrigerator does not close properly because it is not level, your motors will be overworked and condensation will form inside. Make sure the machine is level by placing a level on top of it. Then, using the machine’s leveling feet, adjust the refrigerator until it is level.
Every Six Months Maintenance
In order to provide clean water and ice, and to avoid obstructions and leaks, it is necessary to replace the water filter in the refrigerator. The position of the filter can be found in the owner’s manual, as well as instructions on how to remove it. Run a couple of gallons of water through the filter after you’ve installed a new one to flush out any carbon buildup.
Remove the drip pan and clean the drain hole: Remove food and mineral deposits from the drain pan, then scrub it. (Instructions can be found in your vehicle’s owner’s manual.)
Wrapping Things Up
The best thing to do if you can’t fix the leak yourself is to call in the experts. You may want to think about getting a new refrigerator if the one you have is more than ten years old and the repair costs are prohibitive. A new unit may be more cost-effective than trying to fix a broken one.